BOLT & CLIP KIT 87-06 YAMAHA BANSHEE 632 PIECE POLISHED CARBON STEEL

This fastener kit provides replacement hardware for specified engine, chassis, bodywork and control locations on a Yamaha Banshee ATV. The fasteners are polished to a bright shine and are offered as a lower-cost alternative to a comparable chrome kit.

Specifications

• Kit size: 632 pieces
• Material: Carbon steel

Fastener Locations

The kit is described as covering 49 locations. The supplied locations are:

• Air cleaner
• Brake rotor bolts
• Bearing carrier
• CDI unit
• Chain roller and guide
• Clutch lever mount
• Coil
• Control unit
• Crankcase
• Foot guards
• Front brake reservoir and cap
• Front brake caliper and rotor cover
• Front brake hose distribution block
• Front bumper
• Front fender
• Front shocks
• Fuel tank mount and fuel cock
• Handlebar mount
• Head and cylinder
• Headlight
• Intake
• Kick starter
• Left case cover
• Lower A-arms
• Motor mounts
• Neutral switch cover
• Pipe mounts
• Radiator mounts
• Radiator shroud
• Rear brake caliper
• Rear brake reservoir and pusher
• Rear bumper
• Rear fender
• Rear master cylinder
• Rear shock and linkage, except the fastener with the grease nipple
• Rear skid plate
• Right case cover
• Seat
• Shifter
• Sprocket
• Steering stem mount
• Taillight
• Throttle cover and mount
• Voltage regulator
• Water pump cover
• Wheels

Exclusions

• Main swingarm bolt
• Upper A-arm bolts
• Two motor mount bolts on the bottom of the engine
• Footpeg bolts
• The supplied kit notes state that a few fasteners are unavailable in stainless steel and are therefore not included.

Vehicle Fitments

YAMAHA

• Banshee (all, 1987–2006)